yeh alloy bells and rotars. Ill go out now and measure.
Possibly! I'll look into it....Originally Posted by GTste
yeh alloy bells and rotars. Ill go out now and measure.
excellent cheers. for a fiat coupe 20v turbo. 305mmOriginally Posted by Keri-WMS
from measuring them,they seem to be around 22mm,wasnt the most accurate of measuring.
Cud be 21mm
Would measuring from the outside of the original disk help?
Better pic
Here
Adi
Last edited by GT3turbo; 3rd September 2007 at 21:16.
No much to be honest as you'll be measuring at an angle...Originally Posted by GT3turbo
The part we need to be sure of is the face that has your wheel balancing weight stuck to it in that photo. With 4-pots we'll probably need to move that somewhere else!
Another way would be to use a tape measure are measure the circumfrance of that face, ie "around" it from the inside. From that we can work out the diameter and therefore clearance. It'll be in the 10mm - 0mm range, most are 4mm for some reason.
Sounds like 298.5 x 20.5 to me, the 32mm ones can't wear that thin as there isn't enough meat! You'd be down to vents and fresh air by then!Originally Posted by GTBen
You've lost me a bit! Do you mean you've got a Coupe turbo and want upgraded discs, or that you want to try to fit Coupe turbo discs to a Punto?Originally Posted by GTste
Last edited by Keri-WMS; 3rd September 2007 at 21:52. Reason: Automerged Doublepost
there defo bigger that 20.5.
I will take them off at the weekend and get sum proper measurments.
Sounds like a plan. Are the rotors toast as well as the pads then?Originally Posted by GTBen
not really,the rotars will be fine for abit. I just want drilled and or grooved.
sorry just stating they are the discs i need not punto ones, as i have the coupe 20vt brembo setup on my GT.Originally Posted by Keri-WMS