I'm going to swap to a 2860r as I have one I bought months ago sat about.
Its only mapped by myself on the road so I wasnt expecting it to do over 240hp, It needs some more timing lower down the revs to get the turbo spooling a bit earlier.
Also it needs to go richer below 3000rpm, that might help too.
Last edited by DR_EVIL; 17th December 2011 at 16:43.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
Yeah well they come under Seb4 setup don't they lol, thats what I meant at least.
~1.4bar IIRC.
Nice results Pete!
Nice one pete. your a little down on torque proberly because of it running too rich but i wouldnt richen it up below 3000. if you run it a bit lean it will spool the turbo ever so slightly earlier. Hotter gases etc
fun to watch with a nice glowing manifold
I know what you mean, thing is I have a few power graphs and it always makes better torque lower down on a richer mixture. I might try it richer and see what happens, I can prep a modified map and swap maps between runs. I dont like it running boost and not being as rich as 13:1 though
I took a datalog of the two runs and its very interesing to look at in detail afterwards, so smooth and slow compared to the road going datalogs. If i use a high enough gear to get it smooth and slow then i'm over the speed limit by the time i'm boosting.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
this is very good result nice work
I have on 1.4 bar with serial cam and T2560 (non ballbearig, old model) and unichip 205 hp....
Good results there mate