heard the good news from Andy, awesome results pete
Gt2554r Turbo
Megasquirt MS2 ECU
Standard Block
Standard Rods
Standard Pistons
Standard Crank
Audi s2 throttle
Tubular Manifold
3" Exhaust
Lightly Ported Head
Piper Fast Road Cam
Fmic
440cc Injectors
20psi boost (Machine overreads just over 1psi)
I know I need to pull a little fuel over 6000rpm, Its a safe map!
Last edited by DR_EVIL; 17th December 2011 at 15:23.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
heard the good news from Andy, awesome results pete
Very good result Peter with this "low boost" level!
Great result, good dyno to run on!
That's awesome for standard internals, well done.
It is considering the bottom end i'm running.
Started rusty so hand honed the rust off, Still pitted, one odd piston I got for free that looks like its been bashed with a hammer and one top piston ring I found upstairs in my pile of bits.
You can see the pitting on the cylinder walls after a few hundred miles.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
Hey!
I use this dyno everytime.
The bottom end does not change hp as long as its not broken
193hp when I was seb 4.1 then 219hp on a 35 shot of gas
202hp still seb with added manifold and bigger throttle but didn't add gas.
Now 200 at the wheels, backed up by my 13.6 quarter and 5.1 to 60mph
Last edited by DR_EVIL; 17th December 2011 at 15:45.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
Nice one pete
Nice one Pete! Good result there mate.
Torque could have been abit better? I got 205lbs on the 25r with a standard exhaust manifold and smaller exhaust and inlet.
You going to run nos on it?