Rolling Road Day @ Engine Advantages.

[Breadvan Skillz]

Going to aim for Sunday February the 12th if i get enough interest and all goes to plan.

Its based in Witham, Essex right off of the A12 and not far past Chelmsford heading from the M25.

Stick your name down if your intrested i think we need 10 names to get it for £30 a head. But dont hold me to that.

If not ill go on me own

1. Skillz

[Dean]

1. Skillz
2. gtdean

[xploitGT]

if you car is quite low you may have to remove your bumper to get on the rollers


ill come barry but i wont run

[Puntoboy]

how much ground clearance do you have lee?

[xploitGT]

how much ground clearance do you have lee?

i dunno to be honest but if you have small wheels this might cause issues a lot of side skirts were getting caught and the bottom of the bumper was rubbing on the rollers so i had to remove my bumper

[T]

bugga that, you still owe me a pint for removing your bumper.
my skirts wld hit

[AJ_GT]

My motor is on 17's and the Abarth skirts were touching the floor on those rollers.


Anyway, doubt l'll run. But might pop along......

[Lunchbox]

bugga that, you still owe me a pint for removing your bumper.
my skirts wld hit

Wear some trousers on the day then.

[T]

i'll prob come along and have a butchers

[Breadvan Skillz]

No probs guys.

Ok here is the information.

I spoke with Lawrence from Engine Advantages today.

If its 8 cars or less we will run on Saturday the 11th at a cost of £35

If its 10 cars or more we run on Sunday the 12th at a cost of £30.

He also told me after i mentioned the previous years problems about bumper removal that provided you have 15" or bigger wheels and arent too low youu SHOULD not have a probelm.

And as an added bonus JSC can run his type R as they have doen loads there and there is no issue with the clearance on a type R and the rollers.

So once again i stress i need to know by no later than this Sunday evening as i am phoning to book on Monday morning.

1. Me
2. Gt Dean
3. Minimaniac
4. JSC
5. My mate dean in Zetec-S
6. His dad in 340bhp Cossie

As soon as i get the figures i will pin this to the calendar!!

Many thanks......... Barry