i was really happy with my uno ran 163bhp@7243 rpm and 147lbft@4077, was a good day hope there is going to be drag strip meet soon
Rollers are for tuning, you can't compare figures from different sets/makes of rollers. Seemed the lower power cars were reading fine but the higher fwd figures were strange. It would have bee interesting to get some whp figures because it seemed the flywheel hp calculation might have been the cause. At the end of the day its not possible to do a 12.9 with 235hp
I'd of liked to sample the afr, boost pressure and inlet temps too. I know on my car if the inlet temp goes over 45 its set to pull timing and add fuel to keep the engine safe.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT
i was really happy with my uno ran 163bhp@7243 rpm and 147lbft@4077, was a good day hope there is going to be drag strip meet soon
So there was no boost / afr / inlet temps?
Afr were checked for people that wanted it just unfortunate the external map sensor on the dyno needs replacing but you cant moan for £10
£10!!!??!! Rip off.
Nice to meet you all.
it was a good day, great to see a few gts together
Most Punto GTs i've seen in one place for a long time.
Project Thread
---> Add Your Puntos Here Please <---
http://www.torquestats.com/hall_of_fame/Fiat/Punto+GT