How dafuk did you clean that????
Inlet manifold done
Before
After
Last edited by W8MAN; 7th December 2012 at 21:28.
How dafuk did you clean that????
Basic sand blasting will give the same finish to be honest. Done it with my latest engine and everything comes up great but getting rid of all the sand out of the ports is a complete nightmare.
Is there a better way to clean it such as covering all the ports up and using nitro mors?
Pistons back in New rings and bearings to
Head back on skimmed valves lapped back in and new Valve stem seals
Last edited by W8MAN; 11th December 2012 at 21:17.
top work fella looking very fresh
Nice work. but... you've got the pistons in the wrong way fella. valve cut outs on the pistons should be towards the back of the engine.
agreed with phil