now onto fitted the fmic!!!
this is what i wanted it to look like
the standard inlet manifold has a **** flow coming in from one side and a tiny little rectange hole
so got myself another manifold off another car using the xud engine and cut the govner out and got it all welded up including the egr valve hole and polished are arse off of it so i could see my face!
with gov in
cutting it out
with it out
welded up an polished!
rover cover polished too!
i was running the lucus pump which was very good but the bosch pump has the edge and made it rev just tha tbit better was self lubricating also could run bio fuel through it!
polished boost controller(bit on the top)
now onto fitting the fmic(tmic still in place)
and with it complete! used 2.5 and 3inch pipe work! bit to big really!
i put red silicone on the hot side and blue on the cold