Reply With Quotenot really sure what you mean cos that sounds just like we would do it?
front brakes will be unbalanced if its not been used, a 20 mile run with hard braking would sort it.
been for mot today not to happy bout it what he has failed it on i knew it would fail on some bits but think hes takin the mick check it out
fB]front n/s o/s windscreen washer provides insufficient wash liquid[/B] ( but he said its prob frozen so why he fail it )
rear disks worn (there like brand new just bit rusty not been used for a while )
near and far side (floor to sill ) seat belt anchorage prescribed area is excessively corroded hes put a yellow ring round where the jack goes !!!!
front brakes inballanced ?
not really sure what you mean cos that sounds just like we would do it?
front brakes will be unbalanced if its not been used, a 20 mile run with hard braking would sort it.
but he failed it a rear seat belt too and it was tooked in the seat
and said my angel eye head lights was insecure even though all the bolts that get screwed in for them are in
so he failed it on a seat belt which was dodgy and you tucked under the seat? if so we would do exactly the same, pull it out.Originally Posted by adamp91gvm
and angel eyes aint exactly got brilliant mounting points, light have to be fully secure.
yer he failed it on the ancor point but its no where near it its where the paint has come off for the jack point and he failed it on the seat belt belt being tooked in the seat too
well it must have a hole in the floor for him to have failed it?
no there is no holes hes ringed that part with a yellow crayon
well take it back and get him to show you where the holes are? there has to be a hole to fail it.
erm. If you knew it was going to fail.....why not sort the things you knew it would fail on before you took it?
Posting Permissions