Search:

http://translate.google.co.uk/translate?hl=en&sl=de&u=http://www.youngtimer-bodensee.de/2009_Kopf-16V.html&prev=/search%3Fq%3DFiat%2BX1/9%2B1300%2B16V%26es_sm%3D93

here one fitted on x19 block

Saab aero 2litre t .can get them pretty cheap now ..

depends what type tdo4 you go for ,i would use one of Volvo or Saab ,i used one of wrx (3 stud) i used 12mm steel an drill an tapped studs for new turbo/flange .welded it up to my oe mani ,might...

just different idea if wanted to live map on road an rolling road as to ms

no i haven't done anything with it ,i thought it was only used on vtec ,but after bit of searching they use it alot in france on there gt
just pull the oe chip out an place new one on a ribbon...

Has any one looked at these tune the oe chip (mappable ) ,there listing in the turner pro settings for .gt
http://www.tunerpro.net/downloadBinDefs.htm

tdo4 ,can pick them up for pocket money

yes i know would need balancing an compressor housing machined for bigger wheel

the 20t 11 blade i been looking at ,sure this runs a 20t comp wheel ...

has anyone looked into these for an upgrade
here link just to one site
http://www.xsboostturbochargers.com/products/category/billet-compressor-wheels/

as per title :)

Running omex..I done comp test an its all over place .so checked shims .some are out

checked timing again with laser level an calibrated ecu to alignment with it but no joy ,,
will double check shim size

i have fitted new plugs /leads ,tps sensor ,an moved crank sensor also double check for correct gap

just fitted new engine ,fired it up and runs sweet on tick over an when you rev it, it misfire (sparking in boost pipe ) is like the valve still open ,have double checked timing and is all correct...

dash is out to be sprayed an also clean the wiring up
http://i294.photobucket.com/albums/mm101/le1ght/image_zps9106249e.jpg
http://i294.photobucket.com/albums/mm101/le1ght/image_zps30007f8f.jpg

well from simple engine swap to nearly a full rebuild
here few updates engines all running now sweet but found bit of tin worm ,so sills where patched up where needed ,roll cage has been powder...

Gt an mrk2 are the same Pulleys
I used oe pump as I had a v machine in my trigger wheel .mark used Gt pump .
I also made a bracket for my Gt coilpack .sure mark used a sporting coil pack an...

the 3.08 might be abit small an sit under the bucket sides :-s , i have loads at 3.70 plus
an skimming the cam box will make my shims smaller ,as i had it set up on a bench but when fitted in car...

i have ,prop try local engine refurbishment place see if i can get some ground up

has anyone got these sizes
3.37
3.28
3.45
3.53
3.50
3.08

its was set up on a bench ,but after tlqing the head down there out :shock:
i used a 8mm spanner in the end ground it down an scalloped some out of it so sit under the cam profile

i was going to heat a screw driver up an bend the tip ,will try spanner aswell

what method you use to push the buckets down ,or do i need a shim tool ?? any links

yes by all means ,its easy tbh

http://www.youtube.com/watch?v=6BjI1lG2q4A