Idling too lean, Add fuel.
I Idle at 12-13:1 afr
Printable View
I use your external wiring Pete. Its Pin 47GT to Pin 2MS crank sensor ground and Pin 48GT to pin 24MS its signal wire. thats right? I have jumper from TSEL to VROUT
rotational speed I still fall to zero even if the car is running. I tried to adjust the resistors R52 and 56 but no change.
I tried various maps of the fuel and ignition. but once I open up the throttle and the car is not up to speed at all.
ok I add fuel on idle. but this does not solve my problem.
I dont have a MAPDADDY but only a MAPX4250AP.
but my tooth logger looks like this:
http://imageshack.us/photo/my-images...oothloger.png/
Your vr is wired backwards, swap the + and -
Odd question but does mega squirt log knocking through the knock sensor or do you have to do that yourself?
I dont use knock.
ok I must swap pins 24 and 2 . I will go try it. Thanks
ok Punto runs very well :-) many thanks for help guys
last question: I have msq file from Hobizoli and I chcek his settings for rev counter. I will set up same but my rev counter doesnt work still.
everything works well.
When i use a launch control. I must install a low or high input or both? I have a clutch switch.
Any one use it?
Thanks Kubito