-
RR and 1/4mile today
The punto :) did well.....
162bhp (125 at the wheels) and 190lb/ft at 3780rpm
sounded quite healthy, no smoke at all..... and 101k miles..... bring it on
:(
The skyline was a bit pants on the rollers.... It really held back around 4000 and picked up again at 5500rpm...... I'll get an excel graph knocked up as i threw my scanner out LOL
Its had new 0.8mm iridiums ..... must be a duff coil pack or two :(
It made 200bhp RWHP.... 213lb/ft at 4020rpm
http://www.csdevelopments.com/punto.jpg
http://www.csdevelopments.com/skylineplot.jpg
1/4mile times...... (very slippy)
Skyline:
14.736 at 94.5mph
14.738 at 99.6mph
14.781 at 97.0mph
best and worst 60ft = 2.382 and 3.036
best and worst TV = 99.6mph and 88.2mph (rolled over hehe)
Punto:
15.260 at 93.0mph
15.279 at 91.3mph
15.290 at 93.2mph
Best and worst 60ft = 2.432 and 2.857
Best and worst TV = 99.6mph and 49.8mph (1st to 4th.... hehhe)
-
take it its not a GTR then ?
good to see the gT is running healthy again fee.
-
no, its a GTSt (says that on the graph numbnuts ;) )
its 200bhp at the wheels.... just under flywheel book (250) figure at 240. Adam thinks its either the coil packs or the timing.
Bit disapointed with the 1/4mile time as it will be the last time it will be raced by me. 15.2 on a wet greasy track isnt too bad i suppose [-(
8-)
-
ooops, just seen the graph. should pay more attention :)
-
fee what mods do u av on the punto again, thats a good torque figure.....
komi
-
Allard FMIC (the bigger one)
S/S (undersized) main boostpipe
BCPR7's
Induction kit (could do with being mounted further towards the front of the car)
MBC Dawes type bleed
SEB0 ecu
Dr Evil De-cat
Scorpion catback exhaust
-
190 lb/ft torque and only 125 bhp @ wheels? :???:
Mine made 121 @ wheels (G-Force Aylesbury) (they don't give you a fly figure as that is only a guess unless you remove the engine and actually measure it), and that was standard.
James
-
What boost was u runnning?
-
they never mapped the pressure.... but it was holding around 16psi till redline on the 1/4mile
-
what rollers was that fee?