Hey Adi, this is the firmware am using with the CLT & IAT sensors for Bosch, decided to upload it.
Firmware is 029y4
<a href=''http://hotfile.com/dl/95570917/6f4b460/msns-extra.zip.html"> Download</a>
Printable View
Hey Adi, this is the firmware am using with the CLT & IAT sensors for Bosch, decided to upload it.
Firmware is 029y4
<a href=''http://hotfile.com/dl/95570917/6f4b460/msns-extra.zip.html"> Download</a>
You need to modfy your firmware according to the resistances of the air and water temperature sensors you use.Quote:
Originally Posted by TurboPilot
According to Easytherm the ones burnt are the correct sensors for Bosch. Which ones do you use?
I used the water temperature values from Autodata and the air ones that came with my open element sensor.
Any chance of the values?
Adi
For standard sensors
Coolant degrees C
0 - 6000
20 - 2600
40 - 1100
80 - 320
100 - 200
Air Inlet Degrees C
0 - 6000
20 - 2600
40 - 1100
Where do you input the above? As Easytherm only lets you put three figures per sensor.
Did you change the Bias Resistor value?
http://www.extraefi.co.uk/Pix/easytherm.JPG
Adi
For standard sensors
Coolant degrees C
0 - 6000
40 - 1100
100 - 200
Air Inlet Degrees C
0 - 6000
20 - 2600
40 - 1100
Yea, sorry ignor the red boxes, its just a random screenshot of the program!
Adi