Good luck
Driveshafts for 2.0 16vt Conversion
And the engine mounts too .
Good luck
You need 2x passenger gt driveshafts with coupe inner joints/hubs i think. Make a template of the coupe mount with a piece of metal, and the same for the chassis leg, measure the gap and weld a piece of steel in to make the gap up. Gearbox mount is apparantly more difficult to get right.
Well just gt driveshafts mate I am told
As far as im aware, have you read through the 2litre projects? Theres a wealth of knowledge in Toms, Deans, Ryans, Verns. I assume you have the Coupe/Gt loom, decoded ecu? Id consider Jack-de's conversion set up... Bolt on job, if you don't have an engine already.
A friend of mine for 2.0 punto last night off gumtree and want a pairs so
Doesn't it need a gearbox as well? If your going to re make the mounts use the old ones as a template?
You need engine mount and two gearbox mounts front and back.
I'd be very very very surprised if you get any of them things you have asked for. They are not off the shelf parts.
And in my opinion no very easily made, lots I fiddling and potching about to get them right, especially the rear gearbox mount.
But good luck though.
Sent from my iPhone using Tapatalk
Johnnyboy so you brought the yellow 2 litre then ..?