Maybe worth listing what's mainly left to do on the project? Possibly aid the sale.
Good luck any how.
I was joking dudeOriginally Posted by Todd
Maybe worth listing what's mainly left to do on the project? Possibly aid the sale.
Good luck any how.
Bit more detail about what's done, what will be going with the car, and what is remaining.
The Shell with engine mounted in place, needs a little welding but nothing major. Couple of holes in the floor pan that have been pictured in the project, and in the spare wheel well where the blank usually goes. It has all the rear suspension and sporting beam attached with 2 mint GT3 wheels. The front requires suspension to be able to fit 2 space savers to the car in able to get it on a trailer/lowloader. I have both hubs ready to go on.
The dash and interior is out as the sporting ignition loom requires removing and replacing with GT loom.
Bits that will go with the car
GT rear beam
GT ignition loom
GT-Coupe Engine loom (made by Dean)
Walbro Fuel pump in carrier
2.5" GT exhaust system with 'standard' style tip
Downpipe made for conversion by DanGT, may need some adapting as all 16vt conversions sit differently
Both side drive shafts, on this conversion just use them on opposite sides.
2 big boxes of stuff that was removed and kept from the Donor coupe.
So In essence, the car requires the loom to be installed, and then will be ready to start. Then its plumbing, shafts, swap rear beams, etc.
Hope that helps
Last edited by Todd; 24th June 2012 at 14:53.
Tis a damn bargain!
Prov Sold pending deposit tonight
Nice one anyone we know pal?
A member from here
Last edited by Todd; 8th July 2012 at 08:49.
Deposit taken
sell me the rad then
the rad is going with the car mate, as is the intercooler
Posting Permissions