Megasquirt MS II

[DR_EVIL]

I have 330ohm. They are in the picture I posted earlier.

[kubito]

So I got the U4 memory on Daughter Card. I tried to replace the regulator U5 without success but I still everywhere only 4V. everything, I still check once but without success.

[GT3guy]

I have looked at the datasheet for the voltage regulator LM2937ET-5.0-ND (U5), and it should be outputting 5V under a very wide set of circumstances.

[kubito]

yes I looked too. I still like a man, and will challenge even before the U5.

[kubito]

yes I looked too. I still like a man, and will challenge even before the U5. and when I remove F1 I have a 4.8V on right leg U5.

[kubito]

Hi everyone, I ECU into the car I want to connect the connector to the original ECU. But do not know how I do it confuses anyone involved in scheme? where the wire should I participate? Thank you

[kubito]

Hi,

I need advice on how to engage external wires to the ECU. I have a problem where mounted ignition? how to involve phase sensor to megasquirt? and where to engage coil pack? the VR sensor has 2 wires also do not know how to connect to Megasquirt? could someone please advise me? thanks

[kubito]

Please advise me someone. I need to diagram the Bosch Motronic M2.7 I have a diagram but the wires are in the car otherwise

Thanks

[kubito]

my megasquirt must have: a jumper from VRIN to TACHSELECT, jumper from TSEL to VROUT , also I used TIP120 for PWM. and need two BIP for igniting the two coils. I also have a jumper from JS10 to IGBTIN . for PWM I had to use 1N4001 diode and resistor 330ohm. for second BIP i must use two 330ohm resistors? Is this correct? could someone check?

I have a VR sensor on the crankshaft.
sensor on the cam. (I do not know how to get involved?)
PWM
and setting the teeth 60-2

It's all good?

Thank you

Kubito