Have found one. Can be closed. Thanks!
Type: Posts; User: Acki; Keyword(s):
Have found one. Can be closed. Thanks!
Request Punto GT phase sensor, should be functional ok - shipping to Germany needed.
Pay by Paypal or bank.
PM me please.
Original Düsen haben 240cc.
Wo kommst du her? Irgendwo hab ich auch ne MSQ für GT Düsen denke ich.
Use a MS2extra with Gslender firmware.
Also you should buy a blue tooth module. Is much easier to get stable connections than with USB...
So much money for car and tuning but not for the mapping available?!
A lot of pussies here. :D
Crack after filling with fresh water?
Only to have all facts, the wall thickness is bigger at the area of the head gasket (for around 10mm height), you can see it easily.
The crack at the shown...
No. There were a lot of differences in the cast.
Only cases from the big bore I mentioned.
When you drive without water and you fill on cold water into the hot engine you also can crack the block.
A friend happened this - stupid....
Both sides gone loss?
The 36mm Nut can get a lot of torque.
Check the flatness of the crankshaft. Something is crazy there.
Sure no main bearing cap is at the wrong position???
To the cracked...
Bore for flywheel bolts not deep enough - bolts to long.
I have measured the ARP bolts and it fits but some tolerances in manufacturing of the crankshaft it won't fit.
Use a thicker spacer (two?)...
Next time inform me. I have lay the most parts you are looking for. :D
I played a little bit with ARP bolts last weekend.
They are - on my opinion - a little bit too long for a good clamp. I will shorten my bolts 1mm to get sure that all fits great.
Use 4motion. Can handle much more power.
So the complete package is still available.
1200 is your last price? ;)
Bronze or cast guides are available in Germany.
Crankshaft is sold?
A pin or what? Like stock?
120Nm sounds to much but depends on the bolts I guess.
The enine isn't durable with stock displacement. :D
Use a gauge and check the roundness/flatness of the flywheel when it's mounted to the crankshaft.
When it's balanced you don't feel it but with clutch and gearbox you can have some forces which you...
The flange does not come between crank and flywheel.
It's a big washer (is this the correct name?).
Crank - flywheel - washer - bolts.
Correct torque is a must have.
Clean threads too!
...
Do you have still a PGT Andre? :D
Turbine housing shouldn't have any influence to the Power - when the waste gate is big enough. ;)
There must be something wrong when he didn't reach the 400HP easily!
At LHD cars you don't have to remove the intake (btw in stock condition it's only possible together with the exhaust manifold!).
Loss the screw near the water pump a little bit.
Than loss the...
You have to loss the alternator bolts. :)